Home > News > Content

In The Pcb Board Design, Can You Not Connect The Ground Wire First, And Finally Solve It In The Final Floor?

Maxway Technology Co.,Ltd | Updated: Nov 10, 2018

Yes, but there are prerequisites.

The first is that your signal requirements are not particularly high, and most digital circuits and less demanding analog circuits can.

Secondly, your layout and wiring density are relatively low. You can use the floor and the hole to make the ground wire pass.


If you have higher requirements, draw a multi-layer board. From the 4-layer board, you can have a complete layer as the ground plane.


Contact Us

Maxway Technology Co.,Ltd

Address: 3F, Building 4, Section A, 3rd Industrial Zone of Tangtou, Shiyan Town, Bao'an District, Shenzhen, China

Tel: +86-755-82879548

Fax: +86-755-29810071

David Guo

E-mail: david@maxwaytech.com

Copyright © Maxway Technology Co.,Ltd
Tel: +86-755-82879548
Fax:+86-755-29810071
E-mail:david@maxwaytech.com
Address:3F, Building 4, Section A, 3rd industrial zone of Tangtou, Shiyan Town, Bao'an district, Shenzhen